ZETLIGHT Hanging Kit For ZS7200

Description

Hanging your LED light is usually going to be the easiest method of mounting a light that lets you fine tune the height and overall positioning of the fixture above your aquarium. Each hanging kit comes with adjustable Lok-Rite connections that secure the light in place until you depress the fitting, allowing you to slide the light up and down the main suspension cable.

2 point suspension
Adjustable height
Utilizes tank mounting holes
5.5 feet long main cables

What’s Included?
2x 65″ suspension wires
2x 18″ suspension wires
4x Shieldo suspension pegs
2x Lok-Rite connectors
2x eye hooks
4x small set screws
2x large set screws
4x end clamps

Hanging the ZETLIGHT ZS7200 over an open-top tank in Singapore

An open-top tank looks fantastic in a bright SG living room, but it needs a clean suspension solution, and this kit lets you set the ZS7200 at exactly the height you want above the water. The Lok-Rite connections make fine height adjustment easy, which matters because raising or lowering a fixture a few centimetres noticeably changes intensity at the substrate, useful when you are dialing in coral or plant growth.

For renters, hanging gives you a tidy look without permanently committing a bracket to the tank rim, and the long cables suit higher ceilings common in newer condos. We do remind customers that open tops evaporate faster in our humidity and warmth, so pair a suspended fixture with a top-up routine. Check ceiling anchor strength before you trust the load to a single fixing point.

Find this and related gear in our lighting section. For setup ideas see the light suspension kit guide and our open-top pendant lighting roundup.